VEGAS3DKIDS LLC
  • Home
  • Contact Us

3D PRINTING SUPPLIES

This page contains recommended replacement parts and supplies for the Creality Ender 3 Printer. Vegas3DKids does not receive any commission on sales. All recommendations are from Vegas3DKids. 

MOTHERBOARD FAN

This fan is located below the printing surface. It is very easy to switch out if it stops working. Before changing any part, make sure to unplug the 3D printer. Using an Allen wrench, remove the motherboard cover. Once the cover is removed, unplug the fan and using an Allen wrench remove the old fan. Replace with new fan. Even though there are four holes, the fan is only attached by two screws. Since the cover is off, this is a great time to blow out all the dust on the board. I use a compressed air duster. Replace cover when finished. We purchase our fans from Amazon. They are very inexpensive to replace, and it is good to keep a back up for each printer.
Picture
Picture
Amazon Link
  • Home
  • Contact Us